Cambridge Pavers Driveway & Pavers Nationwide

Cambridge Pavers Driveway & Pavers: The Anaheim Owner’s Guide

We stock and install Cambridge Pavers-compatible driveway and paver systems in Anaheim, with typical installed replacement ranging from $7,000-$18,000 for full paver driveway installation and $5,000-$14,000 for driveway replacement depending on substrate condition and pattern complexity. Most Cambridge Pavers jobs we quote can start within two weeks of written approval, and we carry common repair materials on our trucks for smaller fixes. Homeowners usually notice the problem first as shifting or settling along the driveway edge, or water pooling where the pitch used to drain clean toward the street.

Call (562) 245-4592

Which Cambridge Pavers Models This Applies To

Cambridge Pavers manufactures several product lines that appear across Anaheim properties, and matching the right system matters for both structural performance and color consistency. The ArmorTec and Pavingstones series are the two we encounter most often in Orange County, with ArmorTec carrying the proprietary surface layer that resists salt and UV degradation. To identify your series, check the edge of any loose or lifted paver for the Cambridge stamp, or measure the unit thickness: standard Pavingstones run 60mm (about 2⅜ inches), while ArmorTec driveway-rated units are 80mm (about 3⅛ inches).

The OEM-versus-aftermarket question for Cambridge Pavers is specific. Cambridge’s color blends, particularly the Sherwood and Toffee Onyx lines popular in Anaheim Hills and the Platinum Triangle area, are proprietary dye lots. Generic pavers may match dimensionally but will not blend visually after two or three seasons of California sun exposure. We source factory-original Cambridge units for repairs within visible areas, and will document the dye lot on your written quote so you can verify what arrives on-site. For sub-base or bedding layer materials, we use ASTM C-33 compliant washed concrete sand and Class II road base, which meets or exceeds Cambridge’s installation spec without the brand markup.

Signs Your Cambridge Pavers Driveway & Pavers Is Failing

• Edge restraint failure along the garage or walkway border. The plastic or aluminum edging that locks the field pavers in place has pulled away from the concrete ribbon or spiked through soft soil. In Anaheim’s clay-heavy native soil, especially west of the 5 freeway near Katella, seasonal expansion and contraction works spikes loose over four to six years.
• Individual pavers rocking under foot or tire. This indicates bedding sand erosion or washout beneath the unit, often from irrigation overspray or a failed slope that lets water sit instead of sheet toward the drain. The paver itself is usually intact; the substrate has failed.
• Weed growth through the joints in a previously clean installation. Polymeric sand degrades faster in high-UV climates like ours, and once the binder washes out, organic material collects and germinates. This is both a symptom and an accelerator of joint failure.
• Surface spalling or flaking on the wear layer. On ArmorTec products, this suggests either a manufacturing defect (rare) or repeated exposure to de-icing salts or fertilizer concentrates that chemically attack the cement paste. We see this most on driveways where sprinkler spray hits the same zone daily.
• Visible low spot or dip in the field, typically near the apron or where vehicles turn. This is base failure: the 4-to-6-inch compacted aggregate layer has settled or washed out, often because the original installer skipped geotextile fabric separation between native soil and base rock.

Before

After

Replacement Cost & What’s Included

Full paver driveway installation in Anaheim runs $7,000-$18,000 depending on square footage, pattern complexity (herringbone and basketweave take more cuts than running bond), and whether we need to remove and replace the existing base or can salvage it. Driveway replacement, where we’re pulling failed concrete or asphalt and starting fresh, ranges $5,000-$14,000. Sealing, which we recommend every three to five years in this UV exposure, adds $250-$700.

Every quote we write breaks out base preparation, bedding layer, pavers by the square foot with dye lot noted, edge restraint, joint sand or polymeric, and compaction. Under Clause 1 of the Haven Standard, that written price is fixed: no work proceeds, including any base surprise we find after removal, until a signed change order documents the revision. Our 365-Day Done Right Promise covers the installation, and we leave you with a photo record of the excavated base condition, the compacted lift heights, and the finished surface.

DIY or Call Us?

An owner can safely check a few things before calling. Verify whether the paver is loose or the whole area has settled by probing the joint with a screwdriver: loose sand means bedding failure, solid refusal means possible base failure. Check your irrigation spray pattern, and look for downspouts dumping directly onto the driveway edge. These are useful observations to relay when you call.

What does not work as DIY: base excavation and recompaction requires a plate compactor, laser or string-line grading, and knowledge of how Anaheim’s municipal code treats driveway pitch toward the street (maximum slope and drainage requirements apply). Relaying pavers without addressing the base failure guarantees recurrence within one season. And the silica dust from cutting pavers, or from grinding old polymeric sand joints, is a genuine respiratory hazard without proper extraction and PPE. We carry that equipment; most homeowners do not. Call (562) 245-4592 and we’ll schedule a free estimate with a written scope and price before any work starts.

FAQs